Home | Gallery | Forums | Ads | Store ANTIQUETRACTORS.COM

AntiqueTractors.com Antique Tractor Resource Page

   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   H. Ferguson John Deere Massey Minn. Moline Oliver

Tractor Manuals
Tractor Parts
Engine Kits
Classified Ads
Photo Ads

Discussion Forums
Collector Profiles
Show Guide
Guest Book

Tractor Photos
Garden Tractors
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads

Research Center
Tractor Values
Production Numbers
List Prices
Tune-Up Specs
3-Point Specs
Spark Plug List
Torque Values
Torque Specs
Plow Specs
Clubs & Pubs
JD New Generation
JD HP Chart

Today in History
Pic of the Day
Table of Contents

Related Sites
Garden Tractors
The Tractor Shed
Ford 9N/2N/8N Club
Yesterday's Tractors
More Sites

Tractor Stories

Return to List

Dont Always Assume Its The Carburetor

After several weeks of tinkering on my 1960 Ford 641, I thought I was finished with the work and ready to enjoy hours of leisurely rides around the farm and a few light chores. All the leaks were fixed, the tank was cleaned and the carb rebuilt. I had even rewired the electrics to modern standards with 12 volts and a fuse panel similar to an automobile. I was wrong. One afternoon, I took her out for a ride and she began cutting out and sputtering when I gave her the gas.I figured I had some trash in the carburator and off it came. Everything looked OK and I checked my mixture adjustment and the throttle and governor adjustments. She ran great for about ten minutes. I reasoned that mechanical adjustments such as carbs and linkages don t change suddenly. I then turned to the ignition system. I found that the plugs were fouled slightly and that the distributor cap contacts were coated with carbon. After checking the plug wires, I checked the coil to distributor wire. PAHA the terminal was stuck in the coil and separated from the wire. Evidently someone had pulled the end off the wire and it was making only sporadic contact with the coil. The carbon was due to the arcing and intermittent spark, and that was the culprit also for the fouled plugs and rough running. I went to the parts store and got a new set of plug wires, distributor cap and rotor. After replacing these items I cranked her up and she ran like the proverbial Cadillac. Moral of the story Ive heard this a hundred times - Dont always assume that it s the carburetor.

Bill Radford, NC, entered 2011-08-12
My Email Address: Not Displayed

Return to List

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums

Copyright © 1997-2022 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy