Home | Gallery | Forums | Ads | Store ANTIQUETRACTORS.COM

AntiqueTractors.com Antique Tractor Resource Page

   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   H. Ferguson John Deere Massey Minn. Moline Oliver

Marketplace
Tractor Manuals
Tractor Parts
Engine Kits
Classified Ads
Photo Ads

Community
Discussion Forums
Collector Profiles
Show Guide
Guest Book

Galleries
Tractor Photos
Garden Tractors
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads

Research Center
Tractor Values
Production Numbers
List Prices
Tune-Up Specs
3-Point Specs
Spark Plug List
Torque Values
Torque Specs
Plow Specs
Terminology
Clubs & Pubs
JD New Generation
JD HP Chart

Miscellaneous
Today in History
Pic of the Day
Table of Contents

Related Sites
Garden Tractors
The Tractor Shed
Ford 9N/2N/8N Club
Yesterday's Tractors
More Sites

Tractor Stories

Return to List

Too Young to Know

In 1948 my dad bought a new 8N Ford, it came with a pick-up disk. I got on it the minute it was unloaded. Dad wanted to see just what it would do. I was 14 at the time so when I came to the end of the field there was a turn road and a fence. I pulled the power lift and the front wheels came off the ground - I went through the fence into a public road. I hit the left brake and turned around with the front wheels still up in the air. I put another hole in that fence before I could stop it.

My dad was more than a little upset. Needless to say with all the scratches on the new tractor he helped me get off by grabbing my arm and throwing me to the ground.

Well I didn't get the job of driving that tractor. He assigned me to the irrigation crew. The pipe was laid and this huge pump was backed to the the ditch that was filled with water. By the way this pump was new and had a big Chrysler V/8 with straight exhaust pipes that you could reverse the exhaust and prime the pump. You guessed it - I was told to start the pump and prime it. When it was primed I opened the throttle wide open and when the water hit the end of that pipe all heck broke loose. The pump was pushed backwards and flipped upside down in that ditch full of water. This all happened as my Dad watched from his car.

I had to me a job in a store as I was not allowed to touch not even a hammer after that. He always told everyone that I could brake an anvil wirh a rubber hammer.

Tom Elenburg, MS, entered 2000-09-17
My Email Address: Not Displayed

Return to List


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2022 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy