Home | Gallery | Forums | Ads | Store ANTIQUETRACTORS.COM

AntiqueTractors.com Antique Tractor Resource Page

   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   H. Ferguson John Deere Massey Minn. Moline Oliver

Tractor Manuals
Tractor Parts
Engine Kits
Classified Ads
Photo Ads

Discussion Forums
Collector Profiles
Show Guide
Guest Book

Tractor Photos
Garden Tractors
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads

Research Center
Tractor Values
Production Numbers
List Prices
Tune-Up Specs
3-Point Specs
Spark Plug List
Torque Values
Torque Specs
Plow Specs
Clubs & Pubs
JD New Generation
JD HP Chart

Today in History
Pic of the Day
Table of Contents

Related Sites
Garden Tractors
The Tractor Shed
Ford 9N/2N/8N Club
Yesterday's Tractors
More Sites

Tractor Stories

Return to List

Near Disaster

Late in 2000 I bought a 43' Allis Chalmers C. It needed a fare amount of work, but it ran. It still had steel wheels which would later be part of the problem. I arived early in the morning to pick up the tractor, a friend and I came with a flatbed trailer. Clyde my friend, told me to start it up and bring it round to load it. Well It was the first time I ever drove the C and the steel on the pavement of the lot where we were loading it made alot of noise and was somewhat distracting. We had to modify the ramps on the trailer to accomadate the tight front wheel. Well I got the front end onto the trailer changed the ramps and brought the back on. The ramps were metal and the tractor bucked and made alot of noise on its way up. Finally loaded and ready to head home. Got it home, clyde had me pull it off the trailer, the metal on metal of the ramps and tires made it slippery, while backing down, I touched the right brake, which sent the tractor sliding sidways off the trailer, to the ground luckily I was able to hit the clutch and brakes. For several minutes I sat with the front wheels resting barely on the trailer which was rather high. Clyde managed to pile some blocks under the front end and I eased it down. If the tractor would have been much high on the ramps it could have been a very bad situation. Luckily Clyde myself and the tractor walked away somewhat shaken, but with out a scratch. Be careful unloading. . . .

Bandit, PA, entered 2001-01-05
My Email Address: Not Displayed

Return to List

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums

Copyright © 1997-2022 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy